An update! I got the sides done today, and have the frame in place.
The next step is to put a roof on it, which I can do next week, and it should be waterproof then!
Here is one of the side panels
This the frame in place
Doors and bike fit underneath!
I've got it covered with some tarpaulin for the time being, but I've got some pallet planks which I am going to create the roof with. Should have it covered this week, and then I'll fit the doors next week! Finally, I'll get around to putting earth on the top for my herb garden!
Bike shed & Beer crates from Pallets
Re: Bike shed & Beer crates from Pallets
Read my blog at http://www.inglepingle.co.uk
- wulf
- A selfsufficientish Regular
- Posts: 1184
- Joined: Sat Mar 19, 2005 8:41 am
- Location: Oxford, UK
- Contact:
Re: Bike shed & Beer crates from Pallets
I constructed something similar:
Edible Roof Garden by basswulf, on Flickr
Two notes worth considering from my attempt:
1. The small "roof garden" box hasn't proved to be a huge success; I think the soil was a bit shallow (c. 5") and maybe needed a more effective water retaining mulch.
2. I used left over polythene from my polytunnel to form the cover; I've had to make a few modifications to hold it in place as, when just draped over the top, it bangs around in the wind.
Wulf
ps. ... and it looks like you are a more accomplished woodworker than I am!
Edible Roof Garden by basswulf, on Flickr
Two notes worth considering from my attempt:
1. The small "roof garden" box hasn't proved to be a huge success; I think the soil was a bit shallow (c. 5") and maybe needed a more effective water retaining mulch.
2. I used left over polythene from my polytunnel to form the cover; I've had to make a few modifications to hold it in place as, when just draped over the top, it bangs around in the wind.
Wulf
ps. ... and it looks like you are a more accomplished woodworker than I am!
Re: Bike shed & Beer crates from Pallets
Nice work Wulf!
My woodworking is a combination of a helpful father and too much reading!
Thanks for the notes:
1) My roof is sloped as much as yours, and probably just as deep, but I have used a waterproof lining to create a little pool of water at the bottom of the slope. This should feed moisture to the earth, I'll be sure to post results up on it.
2) My shed was looking like yours for two days, using some tarpaulin to keep the water out whilst I waited for an opportunity to get the roof finished. It made a lot of noise with heavy rain falling on it, and also blew everywhere - where I live is very windy so it's not good! Fortunately, I got the roof finished today, so I don't have to use the tarpaulin anymore. One more sunny day when I'm not in work and I'll have the doors on and everything finished!
Here's the work done today:
The roof is 3 small pallets fixed together.
I created a drip edge underneath with a quarter round floor edge so when the waterproof membrane is fixed around, it will allow the water to drip off at this edge.
I also got the waterproofing on, but it was dark when I finished, so didn't get any photos! I'll probably post those photos up when I finish the doors.
My woodworking is a combination of a helpful father and too much reading!
Thanks for the notes:
1) My roof is sloped as much as yours, and probably just as deep, but I have used a waterproof lining to create a little pool of water at the bottom of the slope. This should feed moisture to the earth, I'll be sure to post results up on it.
2) My shed was looking like yours for two days, using some tarpaulin to keep the water out whilst I waited for an opportunity to get the roof finished. It made a lot of noise with heavy rain falling on it, and also blew everywhere - where I live is very windy so it's not good! Fortunately, I got the roof finished today, so I don't have to use the tarpaulin anymore. One more sunny day when I'm not in work and I'll have the doors on and everything finished!
Here's the work done today:
The roof is 3 small pallets fixed together.
I created a drip edge underneath with a quarter round floor edge so when the waterproof membrane is fixed around, it will allow the water to drip off at this edge.
I also got the waterproofing on, but it was dark when I finished, so didn't get any photos! I'll probably post those photos up when I finish the doors.
Read my blog at http://www.inglepingle.co.uk
Re: Bike shed & Beer crates from Pallets
I thought I would complete the circle and post up my finished bike shed here - I finished it last summer but I've been so busy with my other projects (see website) that I hadn't got around to posting up the photos.
Here it is in all it's glory.
I abandoned the green roof idea because of the difficulties of getting a decent waterproofing layer sorted, so for the moment, it's roofing felt. Perhaps I might improve on this when I've got more time and materials to spare. The doors are great, and the shed has a very solid feel to it.
I can fit three bikes in it, at a push. Not bad for about £10 of materials! (hinges, screws and a padlock)
Here it is in all it's glory.
I abandoned the green roof idea because of the difficulties of getting a decent waterproofing layer sorted, so for the moment, it's roofing felt. Perhaps I might improve on this when I've got more time and materials to spare. The doors are great, and the shed has a very solid feel to it.
I can fit three bikes in it, at a push. Not bad for about £10 of materials! (hinges, screws and a padlock)
Read my blog at http://www.inglepingle.co.uk
- Green Aura
- Site Admin
- Posts: 9313
- Joined: Thu Feb 07, 2008 8:16 pm
- latitude: 58.569279
- longitude: -4.762620
- Location: North West Highlands
Re: Bike shed & Beer crates from Pallets
That looks brilliant, very robust.
Maggie
Never doubt that you can change history. You already have. Marge Piercy
Life shrinks or expands in proportion to one's courage. Anais Nin
Never doubt that you can change history. You already have. Marge Piercy
Life shrinks or expands in proportion to one's courage. Anais Nin